HP 4200 Maintenance Kit Reset Procedure
Posted by Ed Dayton, Last modified by Ed Dayton on 06 December 2017 03:32 PM
After a maintenance kit is installed, the
maintenance-kit counter must be reset.
1 Turn the printer off.
2 Hold down (SELECT button), and then turn on
the printer power. Continue holding down until all
three printer control-panel lights flash once and
then remain on. This might take up to 10 seconds.
3 Press (UP ARROW button) to scroll to NEW
4 Press to reset the maintenance-kit counter.”
Then replace the rest with: “To verify the counter
reset: Press (SELECT button) or the MENU
button to open the menus. Use (UP ARROW
button) or (DOWN ARROW button) to scroll to
INFORMATION, and then press . Use or to
scroll to PRINT CONFIGURATION, and then .
Verify that Pages Since Last Maintenance = 0.